chadm1967
02-18-2001, 12:05 AM
Hi all,
I'm running Red Hat 7 and just downloaded and installed CUPS. Everything went fine and it even says that it's running when the system boots up but I can't seem to access it to configure my printer. When I try to run it, I just get a "command not found" error. Anyone have any ideas?
Thanks for the help.
I'm running Red Hat 7 and just downloaded and installed CUPS. Everything went fine and it even says that it's running when the system boots up but I can't seem to access it to configure my printer. When I try to run it, I just get a "command not found" error. Anyone have any ideas?
Thanks for the help.