mingwuming
10-09-2001, 06:33 PM
I have a D-Link USB network card..how can i config it under Redhat7.1. I am using cable conection. :confused:
[ 09 October 2001: Message edited by: mingwuming ]
[ 09 October 2001: Message edited by: mingwuming ]
Click to See Complete Forum and Search --> : Config USB network Card in RedHat7.1
bdg1983
10-10-2001, 06:07 AM
I'm not sure how it's done. Is usb support enabled?
You might try www.linux-usb.org (http://www.linux-usb.org) as they have quite a few articles on setting up usb and devices.
Did you network card come with any modules for Linux?
Personally I would just go out a buy myself a regular pci network card instead of fooling around with a usb nic.
You might try www.linux-usb.org (http://www.linux-usb.org) as they have quite a few articles on setting up usb and devices.
Did you network card come with any modules for Linux?
Personally I would just go out a buy myself a regular pci network card instead of fooling around with a usb nic.
mingwuming
10-10-2001, 07:52 AM
but it works perfect in Mandrake linux......
anyway,,i will buy a PCI one...
:confused:
anyway,,i will buy a PCI one...
:confused:
bdg1983
10-10-2001, 05:54 PM
You don't have to buy a pci card.
If it worked fine in Mandrake, then why are you using Redhat?
Whatever you did in Mandrake to get it to work, can you not do the same for Redhat?
If it worked fine in Mandrake, then why are you using Redhat?
Whatever you did in Mandrake to get it to work, can you not do the same for Redhat?
justlinux.com
Copyright Internet.com Inc. All Rights Reserved.
Copyright Internet.com Inc. All Rights Reserved.