So close - Linksys wireless on SuSe10 / ndiswrapper

[-nick]

Hi Folks,
I know this topic has been hashed out, but I can't seem to find how to finish the last few steps to get my wireless up and going. I followed the directions for installing ndiswrapper and the Linksys driver appeared to load up just fine. I can run 'iwlist wlan0 scan' and see all the availble access points, including my own. And I have temporarily disabled any security encryption on the router so I can connect easily. Yet, when I pull my ethernet cord out I don't have any connection to the web.

Where to from here??

regards,
nick

[je_fro]

perhaps you need to set the default gateway?
what gui tools are availible for you to configure eth0 and eth1 ?

[dkeav]

have you tried running your dhcp client program? dhclient wlan0 or dhcpcd wlan0, you might have to set your essid with iwconfig first