eduncan
03-05-2005, 11:45 AM
Hi,
I just recently installed Vector Linux on my old laptop, (Compaq Presario 1236, 266mhz)
When linux boots, it recognizes the network card, but doesn't assign it an IP address, even though I selected DHCP at the network configuration during install. Is there something I need to edit regarding PCMCIA networking? Any help would be appreciated.
Thanks
Eric
I just recently installed Vector Linux on my old laptop, (Compaq Presario 1236, 266mhz)
When linux boots, it recognizes the network card, but doesn't assign it an IP address, even though I selected DHCP at the network configuration during install. Is there something I need to edit regarding PCMCIA networking? Any help would be appreciated.
Thanks
Eric