mhacleth
08-26-2004, 03:35 AM
I am trying to install Slack 10 on an old Acer NoteLight. So far, I could get up to the boot prompt where I can begin the install.
The problem lies with the hard disk. I cannot partition it using fdisk nor cfdisk. Here's the error message i saw in dmesg:
==========================================
hda: read_intr: error=0x04 {Drive StatusError}
hda: read_intr: status = 0x51 {DriveReady SeekComplete Error}
end_request: I/O Error, dev 3:00 (hda), sector 6
unable to read partition table
==========================================
is my hda still usable? is there a utility i can use to fix this.
cat /proc/cpuinfo
======================================
processor : 0
vendor_id : GenuineIntel
cpu family : 5
model : 7
model name : Mobile Pentium 75 - 200
cpu MHz : 100.231
fdiv_bug : no
hlt_bug : no
f00f_bug : yes
coma_bug : no
fpu : yes
fpu_exception : yes
cpuid level : 1
wp : yes
flags : fpu vme de pse tsc msr mce cx8
bogomips : 199.8
======================================
24MB RAM
Thanks
Mhac
The problem lies with the hard disk. I cannot partition it using fdisk nor cfdisk. Here's the error message i saw in dmesg:
==========================================
hda: read_intr: error=0x04 {Drive StatusError}
hda: read_intr: status = 0x51 {DriveReady SeekComplete Error}
end_request: I/O Error, dev 3:00 (hda), sector 6
unable to read partition table
==========================================
is my hda still usable? is there a utility i can use to fix this.
cat /proc/cpuinfo
======================================
processor : 0
vendor_id : GenuineIntel
cpu family : 5
model : 7
model name : Mobile Pentium 75 - 200
cpu MHz : 100.231
fdiv_bug : no
hlt_bug : no
f00f_bug : yes
coma_bug : no
fpu : yes
fpu_exception : yes
cpuid level : 1
wp : yes
flags : fpu vme de pse tsc msr mce cx8
bogomips : 199.8
======================================
24MB RAM
Thanks
Mhac