Tau
12-30-2003, 07:04 AM
Hello,
I got some problems setting up my Fritz!Card PCI 2.0 on gentoo.
I configured everything as given in the Howto but if i try to dial using isdnctrl (isdnctrl dial ippp0) the imon just shows "calling" as the status.
"tail -f /var/log/messages" shows the following message before redialing:
isdn: fcpcipnp0,ch0 cause: E001B
I'm using the "AVM Fritz!Card PCI/PCIv2/PnP support (EXPERIMENTAL)" driver of the kernel.
lspci shows up the card, but "dmesg|grep HiSax" shows:
HiSax: Total 0 cards defined
HiSax: 2 Channels added
I've already set the nameservers in /etc/resolv.conf and the /etc/ppp/isdn-initialise, isdn-setup, etc scripts as given in the Howto...
Can someone help me?
I got some problems setting up my Fritz!Card PCI 2.0 on gentoo.
I configured everything as given in the Howto but if i try to dial using isdnctrl (isdnctrl dial ippp0) the imon just shows "calling" as the status.
"tail -f /var/log/messages" shows the following message before redialing:
isdn: fcpcipnp0,ch0 cause: E001B
I'm using the "AVM Fritz!Card PCI/PCIv2/PnP support (EXPERIMENTAL)" driver of the kernel.
lspci shows up the card, but "dmesg|grep HiSax" shows:
HiSax: Total 0 cards defined
HiSax: 2 Channels added
I've already set the nameservers in /etc/resolv.conf and the /etc/ppp/isdn-initialise, isdn-setup, etc scripts as given in the Howto...
Can someone help me?